D-LINK DT-220 NIC Type Token-Ring Transfer Rate 4/16Mbps Data Bus 16-bit ISA Topology Ring Wiring Type Unshielded twisted pair Shielded twisted pair (DB-9 port) Boot ROM Available (Built-in Remote Program Load) [Image] BOOT ROM ADDRESS Address SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 SW1/6 C0000h Off On On On On On C2000h Off On On On On Off C4000h Off On On On Off On C6000h Off On On On Off Off C8000h Off On On Off On On CA000h Off On On Off On Off CC000h Off On On Off Off On CE000h Off On On Off Off Off D0000h Off On Off On On On D2000h Off On Off On On Off D4000h Off On Off On Off On D6000h Off On Off On Off Off D8000h Off On Off Off On On DA000h Off On Off Off On Off DC000h Off On Off Off Off On DE000h Off On Off Off Off Off INTERRUPT REQUEST IRQ SW1/7 SW1/8 2/9 On On » 3 On Off 7 Off Off PRIMARY/SECONDARY CARD SELECT Setting SW1/9 » Primary Off Secondary On Note:If two NICs are installed in a system, one must be set to primary, and the other to secondary. SHARED MEMORY SIZE Size SW1/10 SW1/11 8KB On On » 16KB Off On 32KB On Off 64KB Off Off Note:The 16KB option is the only setting that supports memory paging. NETWORK SEGMENT SPEED Speed SW1/12 16Mbps Off 4Mbps On Note:All NICs on the network segment must be set to the same speed. DIAGNOSTIC LED(S) Amber LED Green LED Condition On Off Network speed is set to 4Mbps Off On Network speed is set to 16Mbps Note:The amber LED will light momentarily when power is applied to the NIC. The appropriate LED will